Integral Stopwatch Electronic Verifiable S-01

Description:

Electronic stopwatch S-01 is an electronic device with an autonomous power supply and a liquid crystal indicator (LCD).
The operating principle of an electronic stopwatch is based on the use of a quartz oscillator and a microprocessor, which ensures operation of the device in all modes and output of measurement information to the LCD.
Electronic stopwatches S-01 are intended for use in scientific and industrial activities, sports and other areas that require accurate measurement of time intervals.
The device operates in two modes – “stopwatch” and “clock”.
Mode selection and control in each mode is carried out using the corresponding buttons.
In the “stopwatch” mode, time intervals are measured, measurement results can be stored in memory (the maximum number of measurements is 10), measurement results can be read and erased.
In the “clock” mode, the current time is displayed on a twenty-four hour scale in hours, minutes and seconds.

Electronic stopwatches S-01 are a measuring instrument that are subject to initial verification in the accredited metrology management laboratory of JSC INTEGRAL, the management company of the INTEGRAL holding (accreditation certificate BY/112 3.0276).
Intervalidation interval is 1 year.
Information about verification is reflected in the product passport, verification certificate, as well as on the verification mark (stamp-sticker) on the back cover of the device case.

Electronic stopwatches S-01 are registered in the State Registers of Measuring Instruments:
Republic of Belarus (registration number RB 03 15 1655 20);
Russian Federation (registration number 44154-20);
Republic of Kazakhstan (registration number KZ.02.03.00478-2020/ RB 03 15 1655 20)

Electronic stopwatches S-01 have the ability to control via external electrical circuits.
The circuits of the “START/STOP”, “RESET” buttons, as well as the “+E” power supply are connected to a connector located under the hatch cover in the rear cover of the device housing.
The PLS2-3 male connector is used as a connector on the stopwatch board.
The product kit includes a BLS2-3 female connector.

Сolor: Black
Overall dimensions: 77x58x22mm
Weight: 0.05kg
# S-01